Electromagnetic Flow Meters

The 630 electromagnetic flow meter is an option for conductive liquids. For the GF630/GF632 with LF610/LF612 configuration shown here, confirm meter size, lining, electrodes and signal requirements. It is not suitable for gases, steam or fluids below the conductivity requirement.

Open PDF ↗Technical support ↗

Model: 630 Series
Category: Flow

SPECIFICATIONS

Technical specifications

Parameter	Specification	Unit
Specification scope	GF630/GF632 detector with LF610/LF612 converter; confirm other configurations separately
Minimum fluid conductivity	5	µS/cm
Meter-size range	15–900; connections and lining depend on size	mm
FEP lining temperature	−20 to +100	°C
PTFE lining temperature	−20 to +120	°C
Polyurethane lining temperature	−20 to +60	°C
Signal options	4–20 mA; HART, PROFIBUS-PA or Modbus depending on converter and options

Application and selection notes

Verify fluid conductivity, full-pipe operation and grounding.
Review the chemical compatibility of the lining, electrodes and grounding rings together.
This page includes documentation for several converters. Do not combine their outputs or accuracy specifications into a universal rating.
Contact technical support to confirm the available version, lead time or alternatives.

Verify specifications and options against the documents for your model. Select a technical sheet to enlarge it.